EasyManuals Logo

Mercury Avator 7.5e User Manual

Mercury Avator 7.5e
133 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #39 background imageLoading...
Page #39 background image
Battery Faults
Fault Action
Low SOC – empty battery
Charge the battery.
75327
Blinking LED
Over or under temperature
Move the battery to a‑15‑45
°C (5‑113 °F) temperature
location.
75329
Blinking LED
Overcurrent/short‑circuit
Make sure the battery is
connected to a Mercury
approved charging device.
75330
Blinking LED
Permanent error
Contact an authorized
dealer for service. Do not
attempt to use or charge
the battery.
75332
Steady LED
Battery Installation
IMPORTANT:Never install a battery when the body or casing appears to be
swollen.
Never install a battery that is venting smoke or foul smelling vapors.
Never install a battery that feels hot to the touch.
BATTERY
eng 29 

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Mercury Avator 7.5e and is the answer not in the manual?

Mercury Avator 7.5e Specifications

General IconGeneral
Power SourceElectric
ControlTiller
MountingTransom
Operating Voltage48V
Power750W
Engine TypeElectric motor
Run TimeUp to 1 hour at full throttle
Propeller3-blade
Warranty2 years
Shaft LengthShort

Related product manuals