BATTERIES
How many batteries are being
sold with this outboard?
Provide kWh of each battery
Are switch box connections tight?
Has correct cable stacking been followed with protective covering
installed?
GENERAL HARNESS ROUTING
Proper switch box orientation and mounted in a suitable location?
Proper data harness and power supply wiring retention and strain relief?
Proper wiring service/drip loop to prevent water intrusion?
If equipped are remote control and electric helm connected and proper
strain relief observed?
Does the boat have an electrical bonding circuit?
Harnessing routed free of obstructions and provide chafe protection?
ON-THE-WATER TEST
Is the relief plug installed(if equipped)?
Verify the lanyard stop switch operates.
Displays are fully functional and operational?
F/N/R gear operation verified?
Acceleration from idle RPM is normal?
Top speed ‑ trimmed if power trim
(if equipped).
Top speed ‑ tucked ‑ if power trim
(if equipped).Provide kWh of each
battery
Power trim operates fully throughout range (if equipped)?
Maneuver the boat to port and starboard ensuring proper friction of tiller.
Does the boat maneuver port to starboard in a predictable and
controllable manner?
What was the battery charge level
at before test?
PREDELIVERY INSPECTION (PDI)
eng 121
To Next Page
Loading...
