4. Use the quick release to separate the outboard from the transom bracket.
Refer to Using the Quick Release ‑ Tiller Models Only.
5. Fold the tiller handle to the lowest position.
6. Position the tiller lock lever to the secure locking position.
7. Use the tiller handle as a handle to carry the outboard horizontally.
8. Grip the tiller handle just behind the throttle grip.
9. Carry, transport, or store the outboard in:
• A horizontal position, or use the carrying case (optional accessory) to
carry or roll the outboard along a smooth surface.
• On the port or starboard sides, the cowl has bumpers to help reduce
damage to the cowl when the outboard is stored laying down.
• Vertical hanging from a stand, do not rest the skeg or the propeller
blades on the floor. Use the thumbscrew clamps to secure the
outboard to the stand.
• Horizontal, with the front of the outboard facing up (tiller handle folded
and locked in the down position). The aft side of the cowl has a
bumper to reduce damage to the cowl when the outboard is stored in
this position.
a - Skeg
b - Tiller handle
c - Grip tiller handle location (when carrying)
d - Port and starboard bumper
e - Aft bumper
f - Propeller
TRANSPORTING
60 eng
To Next Page
Loading...
Need help?
General
