Section 5 - Maintenance
Page 58 90-8M0069751 eng APRIL 2012
c. Drain the gear lube into a suitable container.
Bravo Two Bravo Three
a - Fill and drain plug
b - Sealing washer
7. Remove the vent plug and sealing washer. Allow the gear lube to drain completely.
a - Vent plug
b - Sealing washer
IMPORTANT: If any water drains from the fill and drain plug hole, or if the gear lube appears milky, the sterndrive is
leaking and should be checked immediately by your Mercury Diesel authorized repair facility.
8. Lower the sterndrive so that the propeller shaft is level.
9. Fill the sterndrive through the fill and drain plug hole with the specified gear lube until an air‑free stream of lube flows from
the vent plug hole.
Tube Ref No.
Description Where Used Part No.
87
High Performance Gear
Lube
Sterndrive unit 92-858064K01
IMPORTANT: Use only Mercury/Quicksilver High Performance Gear Lube in the sterndrive.
10. Install the vent plug and sealing washer.
11. Continue to pump gear lube into the drive through the fill and drain plug hole until the gear lube appears in the gear lube
monitor.
a
b
14621
a
b
19777
b
a
19066
To Next Page
Loading...
Need help?
General