EasyManua.ls Logo

Mercury V8 250

Mercury V8 250
302 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Dual_TPS_Faults
Fault Type: Horn: Guardian: UFC: Transmission to Helm: Freeze Frame Priority:
Nonsticky Critical 7% 311‑6 Yes 4
Explanation
The throttle position sensors (TPS) do not agree.
Possible Causes
ETC wiring problem
Failed throttle body assembly
Summary of Fault Correction Possibilities
Inspect the wiring to the ETC.
Replace the throttle body assembly.
E ..........
EGT_Overtemp
Fault Type:
Horn: Guardian: UFC: Transmission to Helm: Freeze Frame Priority:
Nonsticky Critical 10% 2124‑20 Yes 4
Explanation
The value from the exhaust gas temperature (EGT) sensor is higher than normal, indicating that the exhaust manifold is
overheating.
Possible Causes
Restricted water flow
Plugged exhaust sprayer
Wiring problem
Defective sensor
Summary of Fault Correction Possibilities
Restore the water flow.
Remove debris from the sprayer.
Inspect the wiring.
Check the sensor, replace if required.
EGT_RangeHigh
Fault Type:
Horn: Guardian: UFC: Transmission to Helm: Freeze Frame Priority:
Nonsticky Caution 100% 572‑24 Yes 2
Explanation
The exhaust gas temperature (EGT) sensor does not appear to be working properly; the PCM received a signal that is above
the valid limit.
Possible Causes
Wiring problem
Defective sensor
Summary of Fault Correction Possibilities
Inspect the wiring to the sensor.
Check the sensor.
Check the exhaust sprayer outlets for obstructions.
Fault Codes
Page 4A-14 © 2018 Mercury Marine 90-8M0146617 eng JULY 2018

Table of Contents

Related product manuals