EasyManua.ls Logo

Mercury V8 250

Mercury V8 250
302 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Calibrate the DTS system (if equipped).
Replace the command module.
ETC_Loss_Of_Control
Fault Type: Horn: Guardian: UFC: Transmission to Helm: Freeze Frame Priority:
Nonsticky Critical 7% 3012‑6 Yes 4
Explanation
The throttle position sensor (TPS) signals indicate that the actual throttle plate position does not match where the PCM thinks it
should be.
Possible Causes
If this fault was triggered while the engine was in the stall state, the fault was created due to a lack of battery voltage, most
likely due to a battery switch being off while the key was turned to the run position.
ETC components failed
Summary of Fault Correction Possibilities
Check the throttle position sensor (TPS) values and throttle % with CDS G3.
Check the connections and pins at the electronic throttle control (ETC).
Inspect the ETC wiring for chaffing, opens, or a short.
Check for obstructions at the ETC plate.
ETC_OutputFault
Fault Type:
Horn: Guardian: UFC: Transmission to Helm: Freeze Frame Priority:
Nonsticky Critical 7% 3013‑6 Yes 3
Explanation
The electronic throttle control (ETC) does not appear to be working properly.
Possible Causes
If this fault was triggered while the engine was in the stall state, the fault was created due to a lack of battery voltage, most
likely due to a battery switch being off while the key was turned to the run position.
ETC components failed
Summary of Fault Correction Possibilities
Check the throttle position sensor (TPS) values and throttle % with CDS G3.
Check the connections and pins at the electronic throttle control (ETC).
Inspect the ETC wiring for chafing, opens, or a short.
Check for obstructions at the ETC plate.
ETC_Sticking
Fault Type:
Horn: Guardian: UFC: Transmission to Helm: Freeze Frame Priority:
Sticky Critical 7% 3014‑6 Yes 4
Explanation
The electronic throttle control (ETC) does not appear to be working properly.
Possible Causes
Obstruction in the throttle body assembly
Wiring problem
Defective ETC
Fault Codes
Page 4A-18 © 2018 Mercury Marine 90-8M0146617 eng JULY 2018

Table of Contents

Related product manuals