This mode can only be achieved on cellular-enabled
nodes - to learn how to install a SIM card into your node,
please visit section 10.a - Cellular: SIM Card Installation.
7. Blinking (any color)
Blinking LEDs indicate that the node is charging its
battery through a source of power. The LEDs blink at a
rate corresponding to the speed of charge: fast blinking
indicates a fast charge and slow blinking indicates a
slower charge. Charge speed reduces when the state of
charge is under 15% or over 90% capacity to preserve
battery health - Issues #4-6.
A mesh network is a self-forming WiFi network where a group
of devices repeat the signal of an internet source to expand its
connection. When deployed together in the same network,
S618 nodes form a mesh network. This requires at least 1 node
to have a stable internet connection in either Ethernet Gateway
or Modem Mode, with the rest in Repeater Mode to extend the
network’s connectivity.
To Next Page
Loading...