card’s notched corner must go in first and the gold pads
must face down towards the batteries.
2. There are no loose antenna cables coming from the SIM
card cutout on the PCB’s heatsink.
3. There are no damages to any of the cellular antennas
located on the node’s inner seal plates. Each small blue or
green PCB should have a thin, black antenna soldered on.
vii. Log onto the dashboard website - please refer to section 9.b
- Upgrading Node Firmware . Ensure that:
1. The node is running the most recent firmware version. If
not, update it to the latest in the node list menu.
2. The frequency channel selection is legal - no red
exclamation point next to the channels is present.
To Next Page
Loading...