18
|
VIKING / VIKING COMBI
Rev. 2.0 (1.8.2017)
Operating instructions
Then turn the handle aside. Make sure that the mixing tool is locked in its
place by trying to lift/pull it out of its place by
pulling at the mixer blade, for example.
It is easiest to attach the mixing tool to the mixer axle
when the kettle is in a tilted position. Push the ring on
the mixing tool into the kettle’s mixer axle and fi t the
mixing tool in place, while the lifting handle is straight
so that the locking device of the lifting handle sets in
the groove at the upper end of the mixer axle.
Safety lid and safety grid for lid opening
It is absolutely forbidden to use the mixer without the safety lid and the safety grid for lid opening (work-
ing safety regulations).
The safety lid and the safety grid for lid opening are to be attached as follows:
1. When the safety lid is closed, put the ends of the hinges into the oblong holes on the front edge of
the safety lid.
Hinge
Safety grid for lid opening
2. Turn the safety grid down to its place, the safety switch enables the operation of the mixer.
3. It is possible to put a stainless steel cover over the safety grid to decrease the steam outfl ow when
cooking.
STOP
To Next Page
Loading...
