General instructions
Function generator 29
Symbols
used
Refer to the operating manual. Incorrect use may damage the unit and
compromise user safety.
Earth
Guarantee
This equipment is guaranteed against any material fault or manufacturing
defect in compliance with the general sale conditions.
During the guarantee period (3 years), the unit may be repaired by the
manufacturer only, the latter reserving the right either to repair or replace
all or part of the unit. In case of return of equipment to the manufacturer,
initial transport costs will be borne by the customer.
The guarantee does not apply following :
• improper use of the unit or its connection to incompatible equipment
• modification of the equipment without explicit authorisation of the
manufacturer’s technical services
• intervention carried out by a person not certified by the manufacturer
• adaptation to a specific application, not provided for in the definition of the
equipment or by the operating manual
• an impact, a fall or a flooding.
The content of this manual may not be reproduced in any form without our
agreement.
Maintenance,
metrological
verification
Before opening the unit, you must disconnect it from the mains power
supply and measurement circuits and make certain there is no static
electricity charge, which might cause the destruction of internal
components.
• Any adjustment, servicing or repair of the unit under power must be
undertaken only by qualified personnel, after acknowledgement of the
instructions in this manual.
• A "qualified person" is a person familiar with the installation,
construction, utilisation and dangers presented. They are authorised to
operate and remove from operation the installation and equipment, in
compliance with safety instructions.
• Return your instrument to your distributor for any work to be done within
or outside the guarantee.
Unpacking
re-packing
All the equipment was verified mechanically and electrically before
shipping.
However, it is wise to proceed with a rapid verification to detect any
possible deterioration which might have occurred during transport; if
necessary, contact our sales department as quickly as possible and
express the appropriate legal reservations to the carrier.
In case of reshipment, use preferably the original packaging and indicate
as clearly as possible, by a note attached to the equipment, the reasons
for the return.
Servicing
Switch off the instrument. Clean it with a moist cloth and soap. Never use
abrasive products, or solvents. Let dry before resuming utilisation.
To Next Page
Loading...
Need help?
General