2640DCT EM-9538-B Rev.5
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
2
Hold down SCALE/↑ button for 3 seconds or more to move on to
Scaling Setting Mode.
• The setting item ‘D PT’ (decimal point position) is indicated.
NOTE
Skip to Step 5 if the default value is acceptable.
3
Press SHIFT button to show the setting and UP button to select the
decimal point position.
• Press UP button to move the decimal point. Select 1 decimal place
(10
-1
).
NOTE
The right gure shows a display example. Select one among “no decimal point”, and “1 decimal place” to “3 decimal
places”.
4
Press SHIFT button to apply the new setting.
• And the setting item is indicated.
5
■ TO GO ON TO SET THE INPUT SCALING VALUE A,
Skip to Step 3 in “3.2 STEP 2. INPUT SCALING VALUE A”.
■ TO QUIT,
Hold down D
ISP/↓ or SCALE/↑ button for 1 second or more to return to Measuring Mode.
To Next Page
Loading...
