MG 40 Series - Confirming Firmware Version; Operating Procedure

5140DCT EM-9538-B Rev.5
MG CO., LTD. www.mgco.jp
5-2-55 Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN
12.3 CONFIRMING FIRMWARE VERSION
The rmware version of the unit can be conrmed.
Conrm the version in the following cases:
• The display is different from the one described in the operating manual.
• The rmware version is necessary to consult us for troubles.
12.3.1 OPERATING PROCEDURE
1
Hold down DISP/↑ button for 3 seconds or more to move on to
Display Setting Mode.
• The setting item ‘AVG’ (moving average sampling No.) is indicated.
2
Press DISP/↓ or SCALE/↑ button to go to the version indication.
• The rmware version number is indicated.
3
Press UP button to indicate another 4 digits of the version num-
ber.
NOTE
• The above gures show the rmware version V1.00.0002.
• The displays depend on the rmware version number.
4
Hold down DISP/↓ or SCALE/↑ button for 1 second or more to return to Measuring Mode.
1,2,
4
2,4
3