MG TF Series User Manual

J:
~
J:
0.:
...
II
..
i
:J.
II:
-l
C
if
<:
..
...
X
III
~
<oD
~
f
ii
:lro
~
1I'III""d' ~ '1 •• 'I"t"'""" t .'."11.'1 ,. '" "t,tt "1'111'1'1" tl.,. " ""I'dld."."'t'I"II".I'J _--.... tt ttl'llll ..
KEY TO INTERNAL ENGINE COMPONENTS
No. DesCflptlon Net. Descriptictn
No.
De" r{ptlo"
I. Main bearing cap--front. 27. Pulley--on crankshaft.
53.
Cap-sprlng-top.
2. Main bearing tap---e;entre.
28. Key-.:rankshaft pUlley.
541.
Patklng ring-valve.
3.
Main bearing cap-rear. 29.
Wastier.
55.
Split
cotters-valve sprlns.
4. Pipe-rear cap.
30. Nut-erankshaft.
56.
Support bracket-s-reeker-shaft.
5. Nuts-bearing tap. 31. 511Ims-nut.
57.
Bolt-5upport bracket (8 mm.),
I
6. Tensloner-ehal n,
32. Camshaft.
58. Bolt-support bracket (10 mm.).
7.
Feed block-tensloner.
33. Chain sprocket.
59. lock plate-support bracket bolts.
60.
Washer-Nos. I and 5 brackets.
8.
Bolt-feed block.
34.
Key-ehaln sprocket.
61. Wastier-Nos. 2 and 3 brackets,
9. Sprlng-tensloner.
35. BoI t....--camsh aft.
62. Rocker-sllalt wIth plugs.
10. Piston complete (with rings and gudgeon pin).
36.
Washer-ehaln sprocket.
J
63.
Plug-rocker-shaft.
II. PIston rings (compression). 37. lock washer....--chaln sprocket.
64. Spacer sprlng-Iong---centre.
12. Piston rjng (oli control).
38.
011 tllrower-eamshaft.
65.
Spacer sprl ng-medlum--outer.
13. Gudgeon pin. 39. crrdlp--camshaft-rear.
66.
Spacer SprinC-5hort-front and rear.
14. Con netting rod with tap and bolts.
40.
Thrust plate-camshaft. 67. Spring cllp-rotker.shaft.
15. Bolt--<onnectlng rod cap.
41.
BearJng---camshaft-front.
68.
Wuher-spring clip.
16. Nut---conneetJnll rod cap bolt. 42.
Bearlng---camsllaft-rear.
69.
Valve
rocker with bush (Nos. "I and 8 valves).
17. Clamp strew---gudgeon pin.
43.
Bearlng-eamshaft-Intermedlate.
70.
Valve rocker with bush (Nos. I and 5 valves).
18.
Sp'rlng washer---clamp
screw.
44.
Screw dowel-bearing
71.
8ush for valve rocker (Nos. 1,4, 5 and 8 valves),
19. Crankshaft complete (with main big-end bearings). 45.
Plain dowel-bearing.
n. Valve rocker with bush (No!. 2 and 6 valves).
20.
Bearing-fronc.
46.
Timing chain.
73.
Valve rocker with bush (Nos. 3 and 7 valves).
7"1. Busllfor valve rocker (Nos. 2. 3. 6 and 7 valves).
21.
Bearing-lntermedlate. 47. Valv! gUide-inlet and exhaust.
75;
Adjusting screw-c-rocker.
22.
Bearing-rear. 48.
Valve-Inlet and exhaust.
76. locknut-adjusting screw.
23. Bearing---connecting rod. 49.
Spring-valve-Inner.
77.
Push-rod assembly.
24.
011 thrower-crankshaft.
50.
Spring-valve-outer.
78.
Valve
tappet.
25. Chain sprocket. 51.
Cap-sprlng-bottom.
79.
Seal-rear bearing.
26-
Key---chaln sprocket,
52.
Oil deflector-valve.
.... _ ~ ~ " ..- , , ' ••••• 1 •• 1' •• 111. I •••• ' .1 111 .'1."" III "11'111'11"1' ,.,. I •• "
>
Wishvilles Classic
Automobile Library

MG TF Series Specifications

General

Brand	MG
Model	TF Series
Category	Automobile
Language	English