MGL Avionics V6 - Reference Guide; Adjust Volume or Test Receiver; Intercom Setup Reference; Switch Active;Standby Frequency

REFERENCE
ADJUST VOLUME or TEST Receiver
Rotate the VOL/TEST knob to adjust volume. Press VOL/TEST knob
to disable squelch for TEST. For Squelch setting enter the First Level
Menu by pressing the MENU button. Press the MENU button again to
exit the menu.
INTERCOM SETUP - Refer to First Level Menu
Suggested starting point: VOGAD MED level 2 or VOX level 7
Microphone level must be set correctly
Select PTT Join/Separate according to equipment installation
SWITCH ACTIVE AND STANDBY FREQUENCY
Press ACTIVE button.
FREQUENCY ENTRY
SET STANDBY FREQUENCY
Press FREQUENCY knob. Standby frequency selection changes
between MHz and KHz. Rotate the knob to set frequency
SELECT 25KHZ OR 8.33KHZ TUNING STEPS
Second Level Menu function
CHANGE TO CHANNEL ENTRY
Press and hold FREQUENCY knob for two seconds
CHANNEL ENTRY
SELECT CHANNEL
Rotate FREQUENCY knob to set channel
CHANGE TO FREQUENCY ENTRY
Press and hold FREQUENCY knob for two seconds
SELECT SCANNING ON/OFF
Press and hold ACTIVE button for one second. Flashing 'ACT' and
'STB' annunciators indicate if scanning is 'ON'
NB: A 'priority scan' setup is available in the second level Menu
SET 121.5 MHz EMERGENCY CHANNEL
Press and hold ACTIVE button for three seconds. Active frequency will
change to 121.500 MHz
Visit
www.MGLAvionics.co.za to download the latest version of this User and
Installation Manual