Micom 3f - ALE Programming; To Enter the ALE Programming Mode

ALE Programming
87
ALE Programming
This ALE Programming mode is used to configure the parameters needed by the ALE function. The
ALE parameters are identified in Figure 7.
Note
The Programming mode is accessible only if the radio is not locked.
After locating the required ALE parameter in the Programming menu, you can change it by pressing
the function key next to the parameter name, and then press the UP/DOWN keys to scroll or set
parameters.
➤ To enter the ALE Programming mode:
1. Press MENU to display the Menu screen.
MICOM-3
CHAN
FREQ
ALE
BIT
MENU
I
2. Press MORE to scroll to the second Menu screen.
MICOM-3
LOCK
PROG
PSW
DIM
MENU
I
3. Press PROG (F2).
4. Press ALE (F2) to enter the ALE Programming mode.
MICOM-3
RAD
ALE
LANG
PROG
5. Press MORE as required to access additional ALE programming
parameters.
MICOM-3
ALE
PROGRAMMING
NET
DIR
AMD
OPT
I
In the ALE Programming mode, you can program the following features (see also Figure 7):
Description See Page …
• NET
Net parameters: station names, options, members and scanned channels. 88
• REC
Edit the list of stations not appearing in the directory from which calls have
been received. This item is displayed only after such calls have been
received, and therefore will not appear when the MICOM-3 is just turned
on.
90
• DIR
Directory: configuration of the ALE address list. 90
• AMD
Messages: preparation of AMD messages to be sent with ALE calls.
Note
You can also edit, or prepare a new message, on-line.
91
• OPT
Options: configuration of the various ALE options, such as PTT timeout,
external alarm, and so on.
91
• AUTO
Autodial parameters: shortcuts for ALE calls to frequently called stations. 93