Microhard Systems IP-921 - Page 86

© Microhard Systems Inc. CONFIDENTIAL 86
IP9xx Series
6.0 Configuration
Repeater
No
Yes
Values
This setting applies to the Master only.
The default value is No, stating there are no Repeaters in the
network.
If there are 1 or more Repeaters in the network, configure this
setting as Yes.
With one or more Repeaters
in the system, a network‘s
throughput is divided in half.
Exercising the option of back-
to-back ‗Repeaters‘ - which
requires 2 IP Series at a
‗Repeater‘ site - eliminates
the division of bandwidth.
If there is more than one
Repeater in a network, the
Repeaters should be
‗registered‘. See ‗Repeater
Registration‘ further along in
this section re how to
accomplish this.