USER INSTRUCTION MANUAL
Page 42 of 49 ENGLISH
12.14 Configuring the Program - the CONFIG menu
1
A number of parameters controlling the program's operation, including safety limits are stored in a
configuration file and may be altered by the Micropace authorised representative. Contact Micropace
or your representative for further information.
The configuration menu is called up by hotkey 'K'. The parameters are shown in Table 8.
User Configuration password is: “henry” or 4546.
1
This is a password protected feature for use only by company representative for customisation of
program to individual site preferences during installation.
To Next Page
Loading...