CARDIAC STIMULATOR
ENGLISH Page 49 of 49
1
1
5
5
MAINTENANCE
Basic maintenance requirements for safe continued operation of the system are listed here. Refer to
the Technical Description for additional recommended preventative maintenance checks.
15.1 Batteries
Internal rechargeable batteries are replaceable only by service technician; refer to Label on underside
of Stimulus Generator Unit, MP3008 for replacement schedule.
15.2 Maintenance and Calibration
(i) Suggested weekly preventative servicing:
Inspect, clean and check the keyboard for correct operation.
Inspect all cables for damage – such as crushing from trolley wheels.
(ii) Perform annual preventative servicing described in Technical Description.
15.3 Cleaning Instructions
(i) The Stimulator is not protected against ingress of liquids and the Operator should protect it
from contamination, particularly by blood on the keyboard and spillage of fluids such as
beverages.
(ii) All Stimulator system components may be externally cleaned using a cloth dampened with
standard hospital equipment cleaning agents such as 10% ammonia or 10% bleach, isopropyl
alcohol, Cidex, or mild soap. Do not spray or pour agents onto the equipment and do not use
acetone solvents.
(iii) Cover Touch Screen with sterile plastic bag if it is to be part of a sterile field to prevent ingress
of liquids or body fluids. To clean the touch screen, use window or glass cleaner.
15.4 Serviceable Life and Disposal
(i) The Stimulator system has an expected supported life span of 7 years.
(ii) Upon decommissioning, dispose of lead acid battery in MP3008 in an
approved disposal or recycling facility. Further information available at
www.micropace.com.au.
(iii) EU-wide legislation as implemented in each Member State requires the
waste electrical and electronic products carrying the mark (right) must be
disposed of separately from normal household waste. This includes
monitors, and electrical accessories, such as signal cables or power
cords. When you need to dispose of you Micropace Stimulator, please
contact the Distributor or Micropace directly.