Machine description
17
Program cycle dis-
play – table view
Once you have switched to the table view using the button, the
following data is displayed:
- Block name
- Program phase countdown
- Holding time
- Program parameters with the associated target and actual values
and the minimum and maximum values reached
It is possible to scroll to other pages using the scroll bar.
The maximum possible program parameters are:
- Material number and Date of manufacture of the mobile unit
- Cycle number
- User information: First name, Last name, User level
- Temperature of the wash water, sensor 1 and 2 measured values
- Temperature in the dispensing phases 1–3, sensor 1 and 2 mea-
sured values
- Temperature of the air during internal drying in phases 1 and 2
- Temperature of the air during external drying in phases 1 and 2
- Water volumes in the program step and the program phase
- Dispensing quantities of the used dispensing systems
- A0-Value
- Conductivity in the water intake and drainage
- Wash pressure for the internal wash water circuit and the Power-
PulseCleaning
- Spray arm speeds
To Next Page
