Technical Information
67
W1113, W1119, W1203, W1213 & W1215 Clothes Washers
4.3 Service Mode
Initial Requirements
1. Finish or cancel any program in operation.
2. Switch off the appliance.
3. Close the door.
Note
Once you begin the access procedure, it must be completed within
10 seconds.
Accessing
1. Press and hold the Start Button while switching the appliance
on with the On/Off Button.
2. Release the Start Button 2 seconds after switching the
appliance on.
3. Immediately press and release the Start Button 2 times.
4. Press and hold down the Start Button a 3rd time, until the Start
LED flashes.
Acknowledgement indicator
Slow flashing Start LED.
Note
Upon entering the Service Mode, The Buzzer LED displays a
flashing rhythm of 2 flashes while the ROM ID is shown in the
display.
Press the Buzzer Button to advance to the FAULT REGISTER
level.
Refer to the Service Mode Tables 070-0 through 070-11.
To Next Page
Loading...
