Miele W1113 - 070-11 Service Mode; Not Used; Flashing; Display

Technical Information
72
W1113, W1119, W1203, W1213 & W1215 Clothes Washers
Table 070-10: Service Mode (Continued from 070-9) (Continued 070-11)
SERVICE LEVEL TEST STEP
Flashing
rhythm of
Buzzer LED
Flashing
rhythm of
Soak LED
Long Short
Selection:
Press Buzzer
button
Selection: Press Start
button
Function
tested/Machine
response
Long Short
Display
Pressure sensor fault F 51
5 1
F51
Tachogenerator fault
(speed sensor)
F 53
5 3
F53
Final spin < 400 rpm F 56
5 6
F56
Undefined fault F 62
6 2
F62
Water path control
unit fault
F 63
6 3
F63
- 2
Fault register
display and
deletion
Drum Lamp not
installed / not
installed correctly.
F 65
6 5
F65
Not used Not active
- -
U0
Water path control
unit position 1 (only if
fitted)
Water intake via
door glass for 10
seconds
- 1
U1
Solenoid valve Y1 or
Y14 / Y40 with water
path control unit,
heating, analog
pressure sensor
Water intake via
compartment I,
until level 1.
Then heats to
35°C.
- 2
U2
Solenoid valve Y 2 or
Y14 / Y40 with water
path control unit,
analog pressure
sensor
Water intake via
compartment II,
until level 2. - 3
U3
Solenoid valves Y1
and Y3 or Y14 / Y40
WPS with water path
control unit, analog
pressure sensor
Water intake via
compartment III
(fabric
conditioner),
until level 3.
- 4
U4
Drain Pump Drainage
- 5
U5
- 3
**Component
Test
Wash drive Drum rotation
with reversing
action
- 6
U6