Miele W1113 - 070-12 Service Mode

Technical Information
73
W1113, W1119, W1203, W1213 & W1215 Clothes Washers
Table 070-11: Service Mode (Continued from 070-10)
SERVICE LEVEL TEST STEP
Flashing
rhythm of
Buzzer LED
Flashing
rhythm of
Soak LED
Long Short
Selection:
Press Buzzer
button
Selection: Press
Start button
Function
tested/Machine
response
Long Short
Display
Drainage and spin
drive
NOTE: Drainage and
spin drive cannot be
performed on a new
unit until one water
intake and drain cycle
is performed
Drainage and
spinning. Spin
speed is
controlled via the
position of the
spin speed
selector.
- 7
U7
Solenoid valve Y
12 / 2Y40 (hot
water, optional)
Water intake via
compartment II
until level III is
reached
- 8
U8
Buzzer Continuous
signal
- 9
U9
- 3
Component
Test
Display and LED
check
Each individual
segment of the
digital display
and the LEDs
flash at the same
time
U0
1 - Door Switch Test
Buzzer ON = Door Closed
Buzzer OFF = Door Open
- 1 -
- -
Sensor / Switch
Test (select the
desired position
using the
START button)
2 – Float Switch Test
Buzzer ON = Not Actuated
(normal)
Buzzer OFF – Actuated (water present)
- 2 -
- 5
Operating
hours counter
display
Long flashing
pulses for
thousands, short
flashing pulses for
hundreds
Example: 12 x
long + 6 x short
= 12000 h + 600
h = 12600 h
X for
X000
h
Y for
Y00 h
-