106
Replacing the Progard Pack and Vent Filter
When
The Progard Pack and Tank Vent Filter should be replaced when the
following Alert message is displayed.
• Alert message = REPLACE PROGARD AND TANK VENT FILTER
Attention
The Progard Pack must be rinsed after it is installed.
Removing
Remove the used Progard Pack by following the steps below.
Step Action Diagram
1 Place the system into
STANDBY Mode.
2
• Open the Milli-Q System left
door.
• Lift up the Pack Locking
Handle.
Continued on next page
To Next Page