40
Installing the Quantum Cartridge
Procedure
Follow the steps below to install a new Quantum Cartridge.
Step Action Diagram
1
• Open the right door of the
Milli-Q System Cabinet.
• Remove the 2 protective caps
located on the ports inside.
2
• Remove the covers on the 2
ports of the Quantum
Cartridge.
• Wet the O-rings with water.
3
• Install the Quantum Cartridge
until it is fully seated.
• Close the right door.
4 One minute later, the Main
LCD shows that a new
Quantum Cartridge is installed.
Continued on next page
To Next Page
Loading...
