Millipore Milli-Q Integral 3 - Summary of Alert Messages

147
Summary of Alert messages
Alert messages
LCD message What it means
CALIBRATION VISIT OVERDUE
XX DAYS
• The Milli-Q System has
determined that a Calibration Visit
is overdue.
• Contact Millipore.
CHECK ASM UV LAMP
• The ASM UV Lamp is not turning
on.
• Contact Millipore.
CHECK UV 185 NM LAMP
• The UV 185 nm Lamp is not
turning on.
• Contact Millipore.
CHECK UV 254 NM LAMP
• The UV 254 nm Lamp is not
turning on.
• Contact Millipore.
EDI LOW INTENSITY
• The Milli-Q System has
determined that the electrical
intensity used by the EDI Module
is below specification.
• Contact Millipore.
EXAMINE INLET STRAINER
• The Milli-Q System has
determined that it is time to clean
the Inlet Strainer.
• Clean the Inlet Strainer and reset
the message.
NEXT CALIBRATION VISIT IN
XX DAYS
• The Milli-Q System is prompting
you that a Calibration Visit should
be scheduled.
• Contact Millipore.
NEXT QUALIFICATION VISIT
IN XX DAYS
• The Milli-Q System is prompting
you that a Qualification Visit
should be scheduled.
• Contact Millipore.
NEXT SERVICE VISIT IN XX
DAYS
• The Milli-Q System is prompting
you that a Service Visit should be
scheduled.
• Contact Millipore.
Continued on next page