39
Main Cabinet tubings, cables and power cord, Continued
Powering the
system
• Plug the power cord into the Milli-Q System.
• Plug the power cord into a source of electrical power.
• The Main LCD shows a series of start-up screens.
Alarm
messages
• Because the Milli-Q System is starting with an empty Tank and without a
Progard Pack or Quantum Cartridge installed, there are alarm messages
displayed.
• These alarms are:
− TANK EMPTY,
− PROGARD PACK OUT, and
− QUANTUM CARTRIDGE OUT.
Cancel Alarms
• When an Alarm message is displayed, follow the instructions on the screen
to cancel the text display of the Alarm.
• Cancel the text displays of the Alarm messages:
− TANK EMPTY,
− QUANTUM CARTRIDGE OUT, and
− PROGARD PACK OUT.
Check the date
• When the Alarm messages are cancelled, check that the displayed date is
correct.
• If necessary, go to the Manager Menu Software and correct the date and
time. See the Software Map in the beginning of the Software Chapter for
more information.
• Do not install a Progard Pack or a Quantum Cartridge until the displayed
date is correct.
To Next Page
Loading...
