49
Rinsing the Quantum Cartridge, Continued
Procedure
Follow the steps below to rinse the Quantum Cartridge.
Step Action Diagram
1
• Locate the clear tubing and
the barbed fitting from the
Milli-Q System Accessories
Bag.
• Screw the barbed fitting onto
the Q-POD Unit.
• Push one end of the clear
tubing onto the end of the
barbed fitting.
• Place the other end of the
clear tubing into a sink.
NOTE:
Do not use any white tape on
the threads of the barbed fitting.
An O-ring is located inside the
Q-POD Unit.
2 The Milli-Q System should be
in READY Mode.
3
• Push the Q-POD Plunger all
the way down and then
release it.
• In a few minutes, water
should come out of the
Q-POD Unit.
Continued on next page
To Next Page
Loading...
