The instrument is equipped with a three-wire electrical grounding-type plug that has a third pin for grounding.
This plug fits in a grounded power outlet only. This is a safety feature.
Do not try to insert the plug into a non-grounded power outlet. If you cannot insert the plug into the
outlet, contact your local electrician to replace the outlet.
Only peripheral devices that comply to UL 60950 are allowed to be connected to the RS232 connector labeled
COM1.
Only the 2D code reader that was delivered with the instrument should be connected to to the RS232/BCR port.
External laser devices connected to to the RS232/BCR port have to comply with the standard IEC 60825-1.
In order to ensure electromagnetic compliance, connect peripheral devices only with double-shielded cables
and only use the power cable and the keypad included in delivery. Use the keypad with MACSQuant X models
only.
Ensure that the main switch as well as the plug of the power cable are easily accessible and located as close to
the operator of the instrument as possible. If it is necessary to disconnect the power supply, unplug the cable
from the power outlet.
The instrument should only be operated from a power source that meets the specifications mentioned on the
product´s electrical ratings label. If you have questions about the type of power source to use, contact your
authorized Miltenyi Biotec service provider or local power company. Do not use extension cords or power strips.
Do not overload an electrical outlet.
Mechanical hazards
Moving and revolving parts are potential mechanical hazards.
Do not open the front access covers while the instrument is in operation. Do not obstruct the
movement of the robotic needle arm and accessory hardware during operation.There is a risk of
puncturing, crushing and shearing bodily parts. Keep fingers etc. away from all moving parts of
the instrument or accessory hardware. Do not circumvent any safety measures or devices. Do not
touch fluid pumps or adjust the tubing while the instrument is in operation. Always switch off the instrument
before adjusting any part of the fluidic system. Always stop or abort a procedure before handling accessory
hardware, e.g., MACSQuant X Orbital Shaker , or loading/removing tubes from the tube rack.
Optical radiation hazards
The MACSQuant X is classified as a Class 1 Mlaser product per standard IEC 60825-1.
The MACSQuant X is equipped with three Continous-Wave Lasers (laser class 3B). These lasers are secured by a
protective housing.
Do not remove the protective housing. Use of controls or adjustments or performance of
procedures other than those specified herein may result in hazardous radiation exposure.
The instrument is equipped with four vertical cavity surface emitting lasers (VCSEL) for automated rack
detection (Class 1M). The radiation is not visible.
Invisible laser radiation. Do not expose users of telescopic optics.
IMPORTANT SAFETY INFORMATION
EN
DEESFRIT
10
To Next Page
Loading...
