FEATURES OF THE DEVICE
The device is capable of cutting thick materials and flexible materials.
The device can cut thick materials of up to 20 mm thick by moving the cutter up and down at high
speed. It can cut a variety of materials such as sponge and fiberboard, which cannot be cut by
conventional cutting plotters.
Heads corresponding to materials are prepared
RT model: Pen/1.5-kg tangential cutter/reciprocal cutter
RC model: Pen/5-kg tangential cutter/reciprocal cutter
Applicable materials
Upgraded reliability and consistent cutting quality
With its four-axis ( X, Y, Z, θ ) software servo control, the device promises upgraded reliability.
With its high-rigid special drive mechanism, the device produces high- precision beautiful cutting
results while preventing overshoot and warp. Furthermore, eccentricity of the cutter holder can be
adjusted through software by the eccentricity correcting function, achieving cutting results with
upgraded accuracy.
Sponge
Vinyl chloride sheet for signboard
Reflecting sheet
Sand-blast rubber
Industrial sheet rubber
Wood rack
Coated board No. 10
RT Model RC Model
Corrugated fiberboard (E to AB corrugation)
Coated board No. 10
Vinyl chloride sheet for signboard
Industrial sheet rubber
Pasteboard
To Next Page
Loading...
Need help?
General
