— 1.17 —
Turning the power off
To turn the power off, check first whether or not there is data received and there remains data that
has not yet been output in the device.
To check for the remaining data, press the
REMOTE
LOCAL
key to cause the device to enter the REMOTE
mode. The amount of data received is displayed on the LCD, and the device starts cutting (plotting)
according to the data displayed.
To clear the remaining data received, press the
REMOTE
LOCAL
key to cause the device to enter the LOCAL
mode, then execute the “data clear” function. (See page 2.48).
1 Turn off the power to the personal
computer that is connected to the de-
vice.
2 Press the POWER OFF switch .
After displaying [POWER DOWN
WAIT] on the LCD, the POWER lamp
goes out to turn the power off.
POWER DOWN WAIT
To Next Page
Loading...
Need help?
General
