Interruption of processing [DATA CLEAR]............................................................ 48
CHAPTER 3 WHEN ABNORMAL CONDITIONS ARE
ENCOUNTERED ........................................................................................ 1
IF ANY OF THE BELOW-STATED PHENOMENA TAKES PLACE ............ 2
Flowchart of checking and adjusting procedures ..................................................... 5
General explanation of the adjustment of tools ........................................................ 6
Adjustment of the cutter ............................................................................................. 6
Adjustment of the eccentricity .................................................................................... 6
Adjustment of the q angle ........................................................................................... 8
Adjustment of the offset .............................................................................................. 9
Adjustment of the roller ............................................................................................ 10
How to adjust the tools .............................................................................................. 14
IF THERE IS A SIGN OF FAILURE ................................................................ 17
The device not at all actuates even when the power to the device is turned on. ............................... 17
The device fails to actuate even when data is transmitted from CAD. ............................................. 17
Error arises when transmitting data. .................................................................................................. 17
There is no reciprocal vibration. .............................................................................. 18
The tool drags on the sheet of paper. ........................................................................ 18
Dotted lines or blurred lines are plotted. ................................................................. 18
Errors that can be corrected by users ...................................................................... 19
Errors that cannot be corrected by users ................................................................ 21
CHAPTER 4 Application functions ......................................................... 1
ASSIGNMENT OF PEN NUMBERS [MODE SET] > [PEN ASIGN] .............. 2
RE-CUT OF THE SAME DATA [COPY] ............................................................ 4
SETTING THE NUMBER CUT FUNCTION ...................................................... 6
[MODE SET] > [MULTI-PASS] ................................................................................. 6
SETTING THE ONE-STROKE CUTTING .......................................................... 8
[MODE SET] > [ONE STROKE] ............................................................................. 8
SETTING THE CUTTER STROKE [MODE SET] > [Z STROKE] ............. 10
SETTING THE UNIT TO BE USED FOR INDICATION ............................. 11
[MODE SET] > [UNIT] ............................................................................................ 11
SETTING THE DUMMY CUT OPERATION OF ........................................... 12
THE SWIEVEL BLADE [MODE SET] > [DUMMY CUT] ............................ 12
INTERFACE OF COMMUNICATION CONDITIONS [INTEFACE] ................ 14
To Next Page
Loading...
Need help?
General
