— 2.31 —
Tangential Crease Swievel
cutter roller blade
R50 speed The speed that is employed when cutting an arc that is O
40 mm or more and less that 50 mm. If [OFF] is
selected, the arc is cut at the previously specified
speed.
R100 speed The speed that is employed when cutting an arc that is O
50 mm or more and less that 100 mm. If [OFF] is
selected, the arc is cut at the previously specified
speed.
VIBRATION Vibration speed can be set to 5 levels. Normally, set O
the vibration speed to 4 or 5. Works that are easily
affected by heat should be cut using a lower vibration
speed. When using cutter holder 2N, set the vibration
to "OFF".
Setting item Description Pen
To Next Page
Loading...
Need help?
General
