Other Useful Functions
3-66
9
Press the key twice for
terminating this function.
• If “2” is set to “PINCH ROLL” and “OFF” is set to “ROLL. SELECT”, only 2 pinch rollers will be
detected at sheet detection.
• When using wider sheet, you may wish to limit the number of pinch roller because you do not
want to leave the trace of the roller on the sheet. In such a case, as there is the possibility that
the sheet driving accuracy will become lower, make the cutting speed and up speed low
enough or set “HEAVY” to [SHEET TYPE] to limit the driving speed. By doing this, you can
gain better cutting result.
END
To Next Page
Loading...
