1-10
Connecting the cables
This plotter uses the USB and RS232C connector
for connection to the host computer.
USB Cable Connection
When connecting the USB cable, you must observe the followings.
Connecting USB driver
As for USB driver connection, refer to “USB Driver Installation Guide” in the FineCut supplied with this
machine
.
(1) Set the
supplied CD for FineCut into the disk drive.
(2) Click [CD-ROM Contents] on the menu.
(3) Open [usb11_installguid(en).pdf] for the plotter used in [Mimaki USB1.1 Driver] folder.
RS-232C Cable Connection
When you want to connect the RS-232C cable, you must observe the following notabilia.
• Connect or disconnect the connectors
carefully. Applying undue force to a
connector may damage the connector.
• Do not plug in or unplug any cable during data transferring.
• Follow the instructions on the LCD if the wizard is displayed when connecting the USB cable.
• When connecting the cables, turn off first the power to the device and that tothe host computer
which the power cable is to be connected.
• Do not plug in or unplug any cable during data transferring.
To Next Page
Loading...
