MIMAKI CG-100SRII - Setting the Tool Conditions; Kinds of the Tool Conditions

2-9
2
Basic Operations
Setting the tool conditions
You must set the tool conditions depending on the intended use.
Kinds of the Tool Conditions
The kinds of the tool conditions include cutting, plotting and pouncing conditions.
See P.2-9 for the way of setting tool conditions.
Kinds Description
Cutting Condition (CUT1 ～ CUT5)
This is the tool conditions for using the cutter.
Plotting Condition (PEN)
This is the tool conditions for using a pen.
Pouncing Condition (PIN)
This is the tool conditions for using POUNCING. You must
set the setting of the dotted cutting to ON in advance.
(
P.3-61)
Cutting Condition (HALF)
This is the tool conditions for performing the dotted cutting.
You must set the setting of the dotted cutting to ON in
advance. (
P.3-59)
• PIN and the HALF are not displayed unless the [POUNCING] and [HALF CUT] functions have
been set.（ P.3-59、3-61）
CUT1 20 050 0 . 30
CUT2 20 080 0 . 30
CUT3 05 150 0 . 30
CUT4 20 060 0 . 30
CUT5 20 070 0 . 30
CUT1 20 050 0 . 30
OFFSET
The distance from the center
of the cutter holder to the
cutter blade
PRESSURE
The pressure required
for cutting
SPEED
The speed of cutting
PEN 40 0 8 0
PEN 40 080
You need not to set OFFSET.
PIN 40 080 002P
PIN 40 080 002P
Pouncing interval value (P)
This is to set the interval of
pouncing.
HALF 20 040 0 . 30
HALF 20 040 0 . 30
OFFSET