3-4
Cutting area
Set the area in which the plotter performs cutting
(plotting).
The area that has a diagonal line extending from the origin
to a given UL (upper left) point is the available cutting
area. The cutting area setting will be cleared by
performing sheet detection again.
1
Press the key to set to the
local mode.
• Confirm in advance that even if you press the key to enter the remote mode, the
plotter does not perform cutting (plotting).
2
Press the jog key , , or
to enter the jog mode.
• Press either one of the jog keys, and you can enter the jog mode.
3
Press the key.
4
Press the jog key , , or
to set the point UL.
5
Press the key to decide the
point UL.
• After displaying the set value for a while, the plotter returns to the local mode.
• Be sure to set the upper left point in the area located in the normal direction from the origin.
• Be sure to set the origin in the cutting area. If the origin is located outside the cutting area, the
plotter will go into an error state.
To Next Page
Loading...
