2-6
How to Install a Ballpoint Pen
1
Put the cap on the pen adapter.
• Use the cap to adjust the pen height.
2
Insert the pen into the pen adapter.
• Insert the pen until the tip of the pen reaches the cap.
3
Fix the tip of the pen.
• Tighten the fixing screw clockwise.
• Be careful not to over-tighten the fixing screw for
the pen adapter. If tightened too much, the ball-
point pen may crack.
4
Remove the cap.
5
Rotate the knob to loosen the holder
presser.
• When you want to use a commercially available ballpoint pen, you must use the pen of 8mm to
9mm in diameter. Image quality may depend on the pen.
(Recommended ballpoint pen: the one available from Pentel Co., Ltd. with the product No.:
K105-A, K105-GA)
• Regarding such ballpoint pens as shown below, the pen inclines to touch the cover when held
by the pen adapter (the pen that the pen holder girth of which may vary, the pen that the pen
holder of which has umbo and differences)
Uneven gauge With steps or bumps
To Next Page
Loading...
