5-4
Cutter blade
Replacing the cutter
If the cutter is chipped or blunt, replace it with a new one. (Accessorry parts number: SPA-0030)
New cutter (low-pressure blade set for PVC sheets: Model SPB-0030) are available from your distributor or
MIMAKI's sales office.
1
Remove the cap located at the edge by
rotating it.
2
Replace the cutter with a new one
using tweezers or the like.
Adjusting the cutter blade
After adjusting the blade edge, set the cut condition and perform test cut to check whether cutting is
performed well.
1
Turn the adjusting knob to adjust the
protruding amount of the cutter.
• arrow to protrude the cutter blade.
( 0.5 mm per revolution)
Name of product Product No. Specifications Remarks
Decentering blade for vinyl sheet SPB-0001
Package of three piecs of blades
Decentering blade for small letters SPB-0003
Package of three piecs of blades
Decentering blade for rubber sheet SPB-0005
Package of three piecs of blades
Decentering blade for reflecting sheet SPB-0006
Package of two piecs of blades
Decentering
blade for fluorescent sheet
SPB-0007
Package of three piecs of blades
Replacing the cutter other than supplied
one
SPB-0030
Package of three piecs of blades
supplied one
• The cutter blade is sharp. Keep your fingers away from the cutter.
• Do not shake or swing the cutter holder; otherwise, the cutter blade may come off, which
is dangerous.
• Keep the cutter out of reach of children. Dispose of the used cutter blade in compliance
with the applicable regulations.
To Next Page
Loading...
