MIMAKI CG-100SRII - Perform DIVISION CUT; Set for DIVISION CUT

3-43
3
Useful Function
Perform DIVISION CUT.
Setting the DIVISION CUT allows you to divide and cut data larger
than the sheet width (DIVISION CUT function).
Set for DIVISION CUT.
1
Press the key in the local
mode.
2
Press the jog key or to select
[SET UP] .
3
Press the key.
4
Press the jog key or to select
[DIVISION CUT] .
5
Press the key.
• With the DVISION CUT function, you can use the
following convenient functions too.
Perform a frame cut:
Together with the cut data, the plotter automatically
cuts out the frame fitted to the size of the cut data.
Put a mark for leaving a margin for gluing:
You can put a “mark” for showing the point for
gluing together the division cut sheets.
You can divide and cut the part
that runs off the edge.
Overlap
margin mark
Frame
DATA CLEAR <ENT >
FUNCTION
SET UP <ENT>
ENTER/HOLD
DIVISIONcut<ent>
DIVISIONcu t :OFF
ENTER/HOLD