MIMAKI CG-100SRII - Set each Device Number for USB Connection

3-58
Set each device number for USB connection
When two and more plotters are connected to a host
computer with USB cables, give different plotter numbers to
the plotters, respectively.
1
Press the key in the local
mode.
2
Press the jog key or to select
[SET UP] .
3
Press the key.
4
Press the jog key or to select
[DEVICE No.] .
5
Press the key.
6
Press the jog key or to select device No. (0 to 99), and
press the key.
7
Press the key twice for terminating this function.
• The setting values are kept in memory even when the power is turned off.
DATA CLEAR <ENT >
FUNCTION
SET UP <ENT>
ENTER/HOLD
DEV I CE No . < e n t >
DEV I CE No . : 0
ENTER/HOLD
ENTER/HOLD
END