MIMAKI CG-100SRII - Clamp; Sheet Sensor

1-8
Clamp
The clamp pressure can be changed in two levels using the clamp pressure lever. Select the higher or lower
level of the clamp pressure that matches the sheet to be used.
Sheet sensor
The sheet sensor detects the presence of the sheet and the sheet length.
The sheet sensors are located at the front and back of the platen, one for each.
• Be sure to set the clamps of the left and right to the same mode for use. If the clamps’ modes
are different, it may cause the sheet misalignment.
• After setting the position of the pinch roller, set the clamp pressure.
Clamp pressure Application
High mode
• For cutting a PVC sheet.
• When a heavy-weight sheet of media (70 kg or more) is
used.
Low mode
• When the impression of the pinch rollers on the sheet of
media are to be minimized.
High mode
Low mode
Raise the clamp pressure lever.
Lower the clamp pressure lever.
The sheet may drift depending on the sheet
type, feed length, or the sheet width.
Sheet sensor