Perform DIVISION CUT.
3-45
3
Useful Function
Cut Data via DIVISION CUT.
1
Send data from the host computer to
the plotter.
• If the data exceeds the available cutting area, the
display shown at right will appear.
2
When cutting completes, the plotter
automatically cuts the frame and area
marked for gluing.
• On the display panel, the time for completing
cutting of the frame and area marked for gluing
appears.
3
Upon completion of the frame cutting,
the plotter will return to local mode.
• Do not replace the sheet when any other display is shown.
4
Set the new origin.
• Move the carriage using jog keys (arrow keys) to establish the origin.
• If the sheet has no space for cutting, replace the sheet with a new one.
5
Press the key to set the plotter in remote mode.
• Feed the sheet by the maximum sheet length necessary for the cuting data and start
cutting.
• If the sheet is not fed or the sheet is not sufficiently long, replace the sheet with a larger
one in step 4 above.
6
Repeat steps 4 and 5.
• Repeat those steps until there is no data that exceeds the sheet width.
• Upon completion of cutting for all the data, the plotter will return to local mode, displaying
the tool conditions
To Next Page
Loading...
