Clamp pressure lever
This lever adjusts the force
by which the clamp is held.
(P.1-8)
Tray
Small tools, such as a retractable
knife and other cutters, can be
placed on.
Roll bar
A roll sheet is placed on the two
roll bars. ( P.2-17)
AC inlet
The power cable is
connected to the AC
inlet.( P.1-11)
Sheet sensor
This sensor detects the
presence of the sheet and
sheet length. ( P.1-8)
Roll stay
Roll stays support the
roll bars. ( P.2-17)
USB / RS-232C
interface connector
The USB and RS-232C
interface connector.
(P.1-10)
To Next Page
Loading...
