3-71
Miscellaneous Settings
3
Useful Function
Command Switching
• Changing the setting value will clear the data in the receiver buffer.
• With a large size of data, the [AUTO] mode may not function normally. In that case, change the setting
to MGL - Ic1 or MGL-IIc.
• Once the plotter receives data from the computer with [AUTO] selected, the display panel indicates the
recognized command and the plotter stars cutting. The display panel may continue indicating a
command name or display [ERR16 UTO I/F] if the command cannot be recognized automatically. In
such a case, change the command setting to MGL-I c1 or the MGL- IIc to perform normal cutting.
• The recognized command by [AUTO] will be effective until the data clear ( P.3-52) is executed or
sheet setting is performed again.
Cutting Mode
Select “QUALITY” in any of the following cases:
• Characters whose sizes are 10 mm or less are to be cut
• Picture patterns or characters that have many sharp corners are to be cut
• Minute cutting is to be performed
However, the edges of finished patterns may be rugged if the data sent from the host computer is too
complicated. In such a case, select “HIGHspd” for smooth finish.
Origin Switching
When the ROTATION function is ON, the origin is as follows:
• Setting the command origin point to the [LOWERrightORIGIN] will expand the cutting area up
to 51 m.
• The cutting area is 3 m if the command origin is set to [CENTER ORIGIN].
To Next Page
Loading...
