The appendix describes the replacement procedure for the cutter
blade and the specifications of the plotter.
Specifications of the main unit........................................... 5-2
Repeatability condition ................................................................5-3
Cutter blade .......................................................................... 5-4
Replacing the cutter ....................................................................5-4
Adjusting the cutter blade ...........................................................5-4
Replacing the cutter other than supplied one .............................5-5
Adjusting blade edge of cutter other than supplied one ..............5-5
Note slip................................................................................ 5-6
Function Flowchart.............................................................. 5-7
Functions invoked with the specific keys ....................................5-7
Functions invoked with the jog mode (jog keys) .........................5-9
Functions ..................................................................................5-10
CHAPTER 5
Appendix
To Next Page
Loading...
