This chapter describes the procedures and settings ranging from
tool installation to cutting (plotting) operation.
Operation flow...................................................................... 2-2
Installing a tool..................................................................... 2-3
Using a cutter ..............................................................................2-3
How to Install a Ballpoint Pen .....................................................2-6
Turning the power on .......................................................... 2-8
Setting the tool conditions.................................................. 2-9
Kinds of the Tool Conditions .......................................................2-9
Set the Tool Conditions .............................................................2-10
Setting a sheet ................................................................... 2-12
Setting a leaf sheet (cut sheet) .................................................2-15
How to Place the Roll Sheet .....................................................2-17
Test cutting (plotting) ........................................................ 2-20
Cutting (plotting)................................................................ 2-21
Setting the origin .......................................................................2-21
Start cutting (plotting) ................................................................2-22
Cut off the Sheet (Manual Cutting) ...........................................2-23
Turning the power off ........................................................ 2-24
CHAPTER 2
Basic Operations
To Next Page
Loading...
