iii
DATA CLEAR - Discontinue Plotting - ..................3-52
Perform SAMPLE CUT
to Find out the Cause of Cutting Error. ...................3-53
Output the Setting List .............................................3-54
Output the received data by the ASCII code
[ASCII DUMP] .........................................................3-55
Set the configurations with a computer ...................3-56
Set each device number for USB connection .........3-58
Perform cutting a dotted line ...................................3-59
Perform plotting with perforated lines ......................3-61
Make the media without uncut area ........................3-63
Select the number of pinch roller to use ..................3-65
Miscellaneous Settings ......................................... 3-67
Switch the display language ....................................3-67
Other Convenient Settings ......................................3-68
Reset the setting values to the initial state. .............3-74
CHAPTER 4 In Case of Trouble
Before taking a phenomenon as a trouble .............. 4-2
Troubles for which error messages
are given on the LCD .............................................. 4-4
Error message ...........................................................4-4
Status message ........................................................4-8
CHAPTER 5 Appendix
Specifications of the main unit ................................ 5-2
Repeatability condition ..............................................5-3
Cutter blade ............................................................ 5-4
Replacing the cutter ..................................................5-4
Adjusting the cutter blade ..........................................5-4
Replacing the cutter other than supplied one ............5-5
Adjusting blade edge of cutter
other than supplied one .............................................5-5
Note slip ................................................................. 5-6
Function Flowchart ................................................. 5-7
Functions invoked with the specific keys ..................5-7
Functions invoked with the jog mode (jog keys) .......5-9
Functions .................................................................5-10
To Next Page
Loading...
