MIMAKI CG-100SRII - Page 40

2-16
5
Press the jog key or to select “LEAF”.
• For "Sheet detection" （ P.2-13）
• ： In the case the sheet is loaded from the rear
： In the case the sheet is loaded from the front
6
Press the jog key or to select
number of pinch rollers to be used.
• When [ROLL. SELECT] is set to [ON], selectthe
number of pinch rollers to be used.
7
Start detecting the sheet.
• When [DUMMY CUT] is set to [ON], after
completing the sheet detection, the plotter
performs dummy cutting operation ( P.3-73) .
• This plotter cannot detect the leaf sheet of longer
than 3m.
PINCH ROLL. :3
A=654 B=459
CUT1 20 050 0 . 30
Unit : mm
Displays the detected
size of the leaf sheet.
Displays the current
settings of tool conditions.