Setting a sheet
2-19
2
Basic Operations
9
Press the jog key or to select
number of pinch rollers to be used.
• When [ROLL. SELECT] is set to [ON], selectthe
number of pinch rollers to be used.
10
Press the key to start to
search the sheet.
• After the sheet width is displayed, dummy cut ( P.3 - 73 )
will be performed.
11
Press the key to pull out the sheet of the length you want to
use.
12
Input the feed amount using the jog key
or .
• Setting value
In “mm” : 0.1 m to 51.0 m (in increments of 0.1 m)
In “inch” : 1 to 167 feet (in increments of 1 ft.)
13
Press the key.
• The sheet will be fed by the input length.
• Before you use the roll sheet, previously pull out the sheet of the length you use to make
enough room. By feeding out the sheet, you can verify if there is any sheet misalignment or
not.
To Next Page
Loading...
