This chapter describes the setting procedures of each functions,
and how to operate the plotter usefully.
Functions in the Jog Mode ................... 3-2
Setting the origin .................................... 3-2
Two-point axis alignment ........................ 3-3
Cutting area ............................................ 3-4
Digitization operation .............................. 3-5
Set the distance compensation............ 3-6
Perform Multiple Cuttings................... 3-10
Cut Out Data with Registration Mark . 3-12
The Flow of Cutting out the
Registered Data ................................... 3-12
Enter the registration mark
detection mode ..................................... 3-12
Precautions in inputting data
with registration marks ......................... 3-13
Set for Detecting
the Registration Marks ......................... 3-18
Method of detecting registration marks 3-23
Confirm the following
when failed in cutting correctly. ............ 3-32
Expand the cutting (plotting) area ..... 3-39
Set the EXPANDS function to ON. ....... 3-39
Switch the cutting (plotting) direction 3-41
The Setting of ROTATION. .................. 3-41
Perform DIVISION CUT........................ 3-43
Set for DIVISION CUT. ......................... 3-43
Cut Data via DIVISION CUT. ............... 3-45
Change the cutting (plotting) order ... 3-46
Set SORTING . .....................................3-47
Sorting sequence ..................................3-49
Other Useful Functions ....................... 3-50
Feed the paper .....................................3-50
HOLD ....................................................3-51
DATA CLEAR - Discontinue Plotting - 3-52
Perform SAMPLE CUT
to Find out the Cause of Cutting Error. .3-53
Output the Setting List ..........................3-54
Output the received data
by the ASCII code [ASCII DUMP] .........3-55
Set the configurations with a computer .3-56
Set each device number
for USB connection ...............................3-58
Perform cutting a dotted line .................3-59
Perform plotting with perforated lines ...3-61
Make the media without uncut area ......3-63
Select the number of pinch roller
to use ....................................................3-65
Miscellaneous Settings ....................... 3-67
Switch the display language .................3-67
Other Convenient Settings ....................3-68
Reset the setting values
to the initial state. ..................................3-74
CHAPTER 3
Useful Function
To Next Page
Loading...
